Top 10 common forklift mishaps ， forklift operation should take note of these matters ！.

Don't undervalue the forklift at work. If the operation is bad, there will certainly be significant accidents in mins, and there are lots of accidents including forklifts.

Situation 1: The forklift cargo obstructed the chauffeur's sight, and the person in front could not be found, resulting in a rolling accident.
Case 2: In order to maintain the balance of the forklift when raising hefty items, the staff members utilized their body weight as the counterweight, which practically triggered casualties.
Case 3: The width of the forklift cargo exceeds the allowable width of the course and holds on the roadside rack, which practically triggers an accident.
Case 4: Forklift is speeding up and surrender during a turn.
Case 5: The forklift driver did not notice the pedestrian, and the pedestrian did not see the forklift.
Instance 6: The forklift lifts the personnel unlawfully, the forklift vehicle driver does not wear the safety belt, the forklift lifter drops and the driver is crushed when the forklift surrender.
Situation 7: The forklift chauffeur did not put on a safety belt and fell from the lorry when it surrendered and was crushed.
Forklift procedure must take note of these matters ：.

Begin.
1. Before beginning, observe the surroundings, and after confirming that there are no challenges that hinder the safety and security of driving, honk the horn first and after that start.
2. For automobiles with hydraulic ( atmospheric pressure) brakes, the brake hydraulic pressure ( atmospheric pressure) gauge have to be risk-free prior to starting.
3. When the forklift begins with a tons, the vehicle driver must first verify that the lots is steady and dependable.
4. The beginning should be slow-moving and stable.

Driving.
1. When driving, the elevation between the bottom end of the fork and the ground must be kept at 300mm-400mm, and the pole should be slanted backward. .
2. Do not lift the fork expensive when driving. When entering and leaving the work website or while driving, be careful that there will certainly be no obstacles in the sky. When the tons is taking a trip, the fork should not be increased expensive, which will impact the security of the forklift. .
3. After unloading, the fork ought to be decreased to the normal driving position before driving. .
4. When transforming, if there are pedestrians or vehicles nearby, the driving signal ought to be released first. High-speed sharp turns are banned. High-speed doglegs will cause the automobile to shed side stability and topple. .
5. When the forklift is downhill, it is purely restricted to switch off the flame and slide, and it is forbidden to brake unexpectedly while driving with lots unless there are unique circumstances.
6. When the forklift is running, it should follow the web traffic rules in the manufacturing facility and have to maintain a particular safety and security range from the vehicle in front. .
7. When the forklift is running, the load must be in the lowest position that does not hinder the driving, and the gantry should be correctly tilted back. The load shall not be raised other than when piling or filling. .
8. The elevation of the tons need to not obstruct the motorist's sight. In special circumstances, when the item affects the forward vision, drive at a reduced rate when turning around.
9. It is prohibited to activate the ramp, neither to drive throughout the ramp. .
10. The secure driving rate of the forklift in the factory area is 5 km/h, and it should drive safely at a reduced rate when going into the production workshop location. .
11. When the forklift is raised, lifted or driven, it is forbidden for personnel to depend on the fork to hold products and play a balancing role. .
12. If troubles are discovered, they will be fixed and reported in a timely manner, and they will certainly never operate with illnesses or hide them.

packing and unloading.
1. When fork-loading things, the distance between both forks ought to be adjusted as required to make the tons of both forks well balanced and not skewed, and one side of the thing ought to be against the shelf. .
2. It is forbidden to collaborate with a single fork or use a fork top or draw. In special conditions, security warning signs need to be set up to remind surrounding pedestrians. .
3. In the process of filling and unloading items, the Stand-on Electric Pallet Stacker forklift must be Stand-on Electric Pallet Stacker stopped with the brake. .
4. The rate of the lorry ought to be sluggish and stable. Take care not to roll the wheels on the dunnage, so as not to stretch the rolled things and hurt individuals. .
5. When using a fork to fork the goods, the fork must be as deep as possible under the tons, and it should be noted that the fork suggestion ought to not touch various other goods or items. The load ought to be maintained with minimal back tilt of the gantry to make sure that the load does not move in reverse. The mast can be tilted ahead a little when the load is reduced to permit easy placement of the tons and extraction of the forks. .
6. It is restricted to fork products at broadband and collide with tough objects with the fork head. .
7. When the forklift is functioning, it is restricted for individuals to stand around the fork, so as to prevent the collapse of the goods and injure people. .
8. Straining is prohibited, and it is forbidden to make use of forks to lift employees to engage in high-altitude operations to prevent high-altitude dropping accidents. .
9. It is not enabled to make use of the brake inertia to slide, put, round or roll objects. .
10. It is not allowed to utilize forks to choose, transform pallet dump.

Leaving .
1. It is prohibited to leave the forklift when the products on the fork impend. Prior to leaving the forklift, you must dump the goods or lower the fork structure.
2. Draw the parking brake deal with to dead or depress the emergency brake button.
3. The engine is switched off and the power is removed. (Except for special scenarios, such as the vehicle driver does not leave the vehicle's view and does not go beyond 1 min).
4. Get rid of the trick. .

Forklift Operation Precautions.
1. Before and after the forklift procedure, the look needs to be examined, and gas, lubricating oil and cooling water should be included.
2. Examine the safety and security efficiency of starting, running and braking.
3. Examine whether the lights and horn signals are full and reliable.
4. During the operation of the forklift, examine whether the stress and temperature are regular.
5. After the forklift is running, the exterior leak should also be examined and the seals ought to be replaced in time.

Forklift Safety Operation Specifications.
1. You have to inspect before leaving the vehicle;.
2. When you encounter a person in front of you throughout driving, you must send a signal at a distance of 5 m;.
3. The driving speed in the factory does not surpass 5 km/h;.
4. When driving, the nadir of the cargo should be 0.3 m ~ 0.4 m in the air;.
5. The transforming must not be too sharp to avoid the tendency of "free switching";.
6. Adding and down the slope needs to be sluggish and consistent, and no turning on the slope is permitted.
7. Do not drive across the gradient. When the slope is higher than 10%, the lorry should be driven backwards when worsening;.
8. When the forklift workers bring the goods and move forward, if they experience huge or hefty goods and go to the motorist's view, they should take the reversing exercise
.
The "Eight Prohibitions" must be adhered to in the operation.
1. Solitary fork procedure is not allowed.
2. It is not allowed to lift the goods for far away driving.
3. It is not enabled to get the goods by passing on the pallet with the fork.
4. It is not permitted to straight shovel chemicals, flammables and various other unsafe chemicals with forks.
5. It is not permitted to make use of inertia pressure to grab the goods.
6. It is not permitted to make use of stopping pressure to expatriation round or easy-to-roll items.
7. It is not enabled to bring individuals to work with the pallet or fork, and it is purely prohibited to stand under the fork after the fork is increased.
8. Do not drive laterally on slopes
.
Auto parking is not allowed under the following conditions.
1. Curves, narrow roads, railway crossings;.
2. Areas with a longitudinal incline above 5%.
3. When there is an challenge on one side of the road, the contrary side of the area with the same length as the barrier need to be within 20 meters at each end.

Web：https://www.onenforklifts.com/
Email：[email protected]
Phone：+86 13827083844